Brand new, Cross hydraulic gear motor. Model 40MH12DACSC. Pressure balanced loading plates for high efficiency. Aluminum body for good heat dissipation. Pressure lubricated Teflon impregnated sleeve bearings. Internal check valves eliminate need for case drain at shaft seal pressures under 250 PSI.
How well will this work for building a hydraulic chain saw
A: With no other information about the system, we cannot say.
Date Submitted: 03/18/2017
will a cross 1.25 hyd motor 40mh12dac sc @ 6gpm 1400psi turn a automotive ac compressor being used as a portable air compressor . only need 30-40psi going for cfm (10-15) is this obtainable or am i going about this wrong?
A: That should work. You would have the hydraulic motor turning about 1100 RPM. Since the air pressure requirement is low that helps keep the power requirement of the drive motor down.