For this and other couplers, do the splines run continuous without a center rib? I need one to slide on a shaft for intermittent engagement of two shafts.
A: The spline does run continuous through the coupler. We do not have any that are splined halfway.
Date Submitted: 04/09/2019
will this also fit the following 2.81 cu in Rexroth AA10VG45DGD2/10R-NSC60F015S Piston Pump
A: If you are referring to item # 9-8558; then yes. The pump shaft is 1" 15 tooth. So is this coupler.
Date Submitted: 12/23/2018
Are these made from 1018 cold rolled steel? Thanks
A: The grade of steel in not specified in the manufacturer literature. All that is stated is that it is machinable, weldable, cold rolled steel and that low hydrogen electrodes are recommended for welding on these pieces.
Date Submitted: 12/14/2018
Do you ship this to The Netherlands ?
A: We do ship worldwide. Please contact our Product Support department with your order and shipping details and we can provide an international quote.
Date Submitted: 11/19/2018
Does this fit a mid mount 2000 rpm pto shaft
A: Frequently mid-mount PTO shafts are 1" 15 tooth, yes. It would be best to double check the shaft in question.
Date Submitted: 10/13/2018
Is this bushing concentric between spline bore and outside diameter? Do you know what this tolerance is?
A: We do not have the engineering data to confirm with any greater detail than we already have. This product is manufactured by G & G Manufacturing in Omaha, Nebraska as part number 163-1615. They may have dimensional prints with the stated tolerances you seek.
Date Submitted: 07/21/2018
Is the OD concentric with ID?
A: Yes. The o.d. of the coupler is 1.499". The i.d. of the coupler at the valley of the female spline is 1.020" for use with 1" o.d. male spline. The i.d. of the coupler's meshing male teeth is 0.889". All diameters are concentric.
Date Submitted: 07/16/2018
hi do you have this product in 1 1/4 inch with 16 spline please.
A: No, we only have 1-1/4 14 tooth spline.
Date Submitted: 08/17/2017
Will you ship this item to Ireland? Having difficulty getting this at a reasonable price this side of the Atlantic Thanks.
A: We ship worldwide. Please contact our Customer Service Department with your information and they can get you an international quote.
Date Submitted: 04/08/2017
Does this coupling fit item #1-3092-6 ?
A: Yes, they are the same spline.
Date Submitted: 09/03/2016
Does this coupling have set screws for attaching to shaft?
A: No, this coupling does not have set screws.
Date Submitted: 08/24/2016
Do you have matching fully splined shaft for this coupler
A: No we don't have an 1" 15 tooth splined shafting.
Date Submitted: 11/23/2015
Do you have the 1" 15t splined coupling in 6" long ? If you do what is the # and cost? Thank you Tom.
A: This item is the only coupling we have for the 1" 15 tooth spline. One possibility would be to use item 1-3090, cut to your desired length with a 1-1561 at each end.