PULLEY CENTRIFUGAL CLUTCH W/BUSHING Brand new, HILLIARD EXTREME DUTY model LD4P-50 pulley centrifugal clutch with bronze bushing. Ideal for chipper shredders, power trowels, concrete mixers, power screeds, air compressors and lawn and garden equipment. Thermodynamically designed clutch shoe increases the clutch''s capacity to absorb heat without damaging clutch springs, resulting in longer life and greater reliability. Easy to install. Overload protection. Made in USA.
Do the clutch shoes have a liner or are they metal to metal contact with drum?
A: There is no liner. It is metal on metal.
Date Submitted: 10/23/2018
I'm Building a band saw mill may use a 18hp motor with 1" shaft what is the best speed to use 1200 kick in or 1800 kick in speed have any idea which is best? LMK Thanks
A: Ultimately, neither clutch should be used. They are rated for 13 Hp max.
Date Submitted: 07/03/2018
What is the datum diameter (measured from the center of the bore to the bottom side of the belt) for the pulley on this clutch? Is it simply 3 inches or is that the height that the flat side of the belt will set at?
A: When pulled hand-tight, the O.D. of an A belt in this pulley is 2 11/16", while the O.D. of a B belt is 3 3/16".
Date Submitted: 10/02/2016
Is it available with a double grooved pulley? Obviously a different part number.
A: We do not carry a double grooved pulley version of this clutch, nor does the manufacturer offer such.
Date Submitted: 03/22/2016
Can this clutch be used on a vertical shaft engine?