HYDRAULIC MOTOR Brand new PARKER model MGG20020-BB1B3. Use as hydraulic pump or motor for agricultural, commercial applications. Geroter design with heavy duty bearings, aluminum case, reversible, Buna-N seals.
If running 2 of these motors together thru a flow divider would the motors stay "in time"?
A: That depends on the flow divider.
Date Submitted: 01/30/2019
I am wanting to build a string weedwacker to be used on a mini excavator could you recommend a motor?
A: If the system flow and pressure were quantified, and a desired rpm were given we may be able to; should one match those values.
Date Submitted: 08/05/2018
Are the high speed hydraulic motors , gear and vane motors?
A: The Parker MGG series of pump/motors are of a geroter design, similar to low-speed, high-torque motors.
Date Submitted: 04/24/2018
i have a 3.5 ft. belt drive snowblower on a bolans tractor, i want to go from belt to hydraulic, it is a single stage chain to belt drive,motor is a 12 hp twin cyl. will this motor work and with what pump? also want a controler that i can have veriable speed
A: There are too many unknown variables to tell. Please contact our Product Support department to discuss your application.
Date Submitted: 08/22/2017
I am searching for a hydraulic motor to install in a mud boat ( used for marsh travel ) it will have roughly a 12'' propeller. This is a project in the infant stages so please answer this as best you can. What torque could I reasonably expect this motor to develop @ 4500 rpm? What flow would I need for 4500 rpm? What hp is required for above?
A: At the rated continuous pressure (2000) psi, the torque would be approximately 144 in/lbs. To achieve 4500 rpm, the input flow would have to be at least 8.77 gpm. The produce that flow and pressure would require at least 16 Hp from an industrial gas or diesel engine. Keep in mind this pump/motor is about the size of a fist, with a 9/16" shaft. If a propeller were to hit something, the shaft would snap.