Brand new. Hydraulic pump driven by 12 volt DC clutch. For use in marine, agricultural and industrial use. Use for remote hydraulics in service trucks, boats, trucks with automatic transmissions, farm tractors, snowplows, etc. SPECIFICATIONS
How would pulley size affect gpm and psi? I noticed the more gpm the less psi.
A: Of the two clutch pump models we carry, the higher volume pump does have a lower overall pressure rating. This is not due to the pulley size, but rather the limitations of the base model pump being used. The smaller version is a 1.45 in³ pump, with this pump being 2.32 in³. For pumps in general, speed is directly proportional to output; with pressure being limited by both design and available horsepower.
Date Submitted: 08/30/2018
What size ports? Inlet and outlet
A: IN SAE 16, OUT SAE 12
Date Submitted: 03/11/2018
Do you have a counter clockwise option ?
A: No, we do not.
Date Submitted: 11/07/2017
What HP electric motor would I need to run this pump?
A: To operate at the rated 2000 rpm and 2200 psi this pump would consume approximately 30 Hp electric.
Date Submitted: 09/06/2017
Is this pump left hand rotation?
A: These pumps are Clockwise rotation as facing the shaft, or right hand as facing the shaft.
Date Submitted: 01/23/2017
What size Pulley? Is there and option between 5/8"s and 1/2 inch belts?
A: The pulley is 7" diameter for 1/2" belts. There is not an option for 5/8" belts.
Date Submitted: 03/14/2016
Will this work on a wrecker truck it has a single hook and with a Ramsey winch and a wheel lift thank you
A: This would be a good source of hydraulic power for use on your truck. It has sufficient flow and pressure for both your functions.
Date Submitted: 12/07/2015
Does the resevior have to be mounted higher than the pump? (if installed on a straight truck, could it be on the engine, and the tank behind the cab on the frame) Thank you. Rick
A: It is always best to have the fluid flow downward from the reservoir to the pump but this can be difficult for pumps mounted under the hood. As long as the pump is not starved for oil alternate mounting would be acceptable.