2 HP 115/230 VAC HYDRAULIC POWER PACK Brand new, SPX model AB-1636 hydraulic power pack made for use with a remote directional control valve (not included). Check valve installed in the pressure port for load holding. Horizontal mount.
what is the correct hyd oil to use with this pump?
A: Customers have reported success with either general purpose all weather hydraulic fluid, or ATF.
Date Submitted: 06/13/2018
I am using this pump to run 2 vertical double acting cylinders. I want to keep the 2 cylinders timed so I am going to use one of your hydraulic flow dividers. Which part number do I need for my volume pump and when this is installed, will the cylinders extend and retract at the same speed regardless if there is more weight on one of the cylinders than the other? Thank you!!!
A: The pump flow is below the smallest rotary divider minimum flow rating, so we cannot recommend using any of the rotary dividers for this application. The 50/50 shuttle-type dividers are not accurate enough to time cylinders. We do not currently offer a divider that will suit your application.
Date Submitted: 09/15/2017
Is this power unit rated for continuous running using an external directional control valve. Our intended use will require the external control valve to be cycled every 3 seconds.
A: The manufacturer does state the duty cycle as continuous, and this unit is made to feed an external DCV.
Date Submitted: 06/10/2017
How do You raise the pressure out put ? Do I need shims under the spring and how thick or what ?
A: These models are already at their maximum pressure setting out of the box. Raising the pressure above the factor setting may lead to failure and a voided warranty.
Date Submitted: 04/20/2017
Do you have a wiring diagram available for this unit? There are six wires: black, yellow, white, blue, orange, and red.
A: The wiring diagram should be outlined on the data tag of the electric motor. Please contact our Technical department if you need further assistance
Date Submitted: 02/08/2017
can i connect a electric foot control to operate this unit
A: Because this power unit requires and external control valve, any foot operated control would have to power the motor and any solenoid operated directional control valving used. If a lever operated directional control valve were used, the foot control would only need to operate the motor. Either way a foot control could be used if wired correctly, and was of the right electrical rating.
Date Submitted: 10/16/2016
Can I use a double acting Cylinder with this pump?
A: This powerpack does not have any valving with it. You can add manual or solenoid operated valves for either single or double acting cylinders. If you want a powerpack with a solenoid operated double acting valve you should order 9-7138.
Date Submitted: 12/10/2015
Does this include a momentary switch to turn the motor on?