Can you please advise the diameter of the exposed drive shaft.
A: As the specifications state: 3/8" diam. x 1" long with 'D' flat.
Date Submitted: 08/07/2018
Do you have any dimensional information for the mounting hole pattern and bolt sizes?
A: Six 10-32 bolt hole face mount on 1-15/16" - 4-3/8" x 2-3/8" centers.
Date Submitted: 03/04/2018
Will this work with a Englander 25 pdvc pellet stove
A: We do not have any information saying what model or make this unit was intended for and cannot say.
Date Submitted: 01/02/2018
What is the temp rating on this reduction motor and are the gears all metal?
A: We have no information regarding the temperature rating, nor the composition of the gears.
Date Submitted: 12/06/2017
While the shaft cannot be repositioned so that it extends from the opposite side of the gearbox is the backside of the shaft exposed?
A: Yes, the back side of the shaft is exposed.
Date Submitted: 09/08/2017
Are motor brushes replaceable in this unit, possibly through what appears to be an opening in the motor case near to the spade connection end? If so, there should be another slot on the other side not shown. If I use a reversible dc brushed motor, I would want to be able to replace the brushes if needed. Thank you.
A: The brushes are not accessible via the case vents. It does not appear they intended the brushes to be serviceable.
Date Submitted: 01/27/2017
Hello, Is there a technical data sheet available for this product? With Torque-speed curves, efficiency data, etc.?
A: We do not have that information for this item.
Date Submitted: 09/27/2016
I see that it is reversible, second, will it handle a rheostat?
A: We have no information regarding it's compatibility with that form of control.
Date Submitted: 07/30/2016
Hi I want to buy this unit and was wondering if the drive shaft can be mounted on the back side of the gear,1.6 RPM 12 VDC GEARMOTOR ITEM NUMBER: 5-1741 Also what power supply would work well with this? Thanks
A: It doesn't appear the shaft can be reversed in the gear case due to the alignment of the gears. It appears that any of the 12VDC power supplies we have would be adequate to power this motor.
Date Submitted: 06/08/2016
The motor I have is 12v, 8w ,2 rpm . Could I buy the 1.6 watt? Even if I had to put the motor on my gear box. Would that work. I can't get parts for my pellet stove
A: This motor is 1.6 RPM wattage is 4.2. This motor may or may not fit on a different gearbox, but would be worth a try if no parts can be found for yours.
Date Submitted: 12/10/2015
what is the distance from motor shaft center to the outside case of the motor?
A: From the center of shaft to top of the case is 1-3/8".