2.8 HP TREADMILL MOTOR New, Icon Health and Fitness model# M-295730 permanent magnet motor with brushes. Built for use in treadmills, ideal for use with speed controller (sold separately). Would also make an excellent DC generator. Rated for 2.8 HP treadmill duty or 2.25 HP (1678W) continuous duty. Internal, normally closed bimetallic switch signals thermal overload.
Requires external source of air-flow over motor for prolonged use. Motor is reversible. Left hand threaded end of shaft requires clockwise rotation.
Power 2.8 HP Treadmill
2.25 HP (1678W) Continuous
Voltage 130 VDC Treadmill
110 VDC Continuous
Amperage 16.1 Amps Treadmill
15.3 Amps Continuous
RPM 8625 RPM @ 130 VDC, No Load
7200 RPM @ 110 VDC, No Load
Mount Two 1/4"-20 Threaded Holes in Case on 2-3/8" Centers
Shaft 17mm dia. x 43mm overall length w/ 1/2"-13 x 5/8" long LH threaded end
Rear Shaft 10mm dia. x 37mm overall length, stepped down to 7.5mm for 26mm
Is the threaded piece removable that is on the end of the hub where the flywheel presses on? I have the same model motor, but my flywheel/pulley is held on by a hex bolt that threads into the hub, so I want to make sure my flywheel assembly will secure correctly to this motor.
A: The threads on the end of the shaft are machined not a separate piece.