3 HP TREADMILL MOTOR W/O EXTERNAL FAN
New, Icon Health and Fitness model# F-309513 permanent magnet motor with brushes. Built for use in treadmills, ideal for use with speed controller. Would also make an excellent DC generator. Rated for 3 HP treadmill duty or 3 HP (2238 W) continuous duty. Internal, normally-closed bimetallic switch signals thermal overload.
Motor housing diameter measures 115mm (4.527"). Removable, heavy (7.6 lb.) steel flywheel mounted onto motor shaft by means of keyway and retention screw. Flywheel measures 172mm (6.772") dia. x 36mm thick. Flywheel has 31mm O.D. ten-groove pulley for serpentine belt.
Power 3 HP (2238 W)
Voltage 130 VDC
Amperage 17.2 Amps
RPM 5265 RPM @ 130 VDC, No Load
Mount Two 5/16"-18 Threaded Holes in Housing on 3" Centers
Front Shaft 17mm dia. x 41mm long, Stepped down to 14mm dia. with 5mm keyway, End tapped M6-1.0
Rear Shaft 1/2" dia. x 13/16" long w/ four grooves for external fan
What is the blue wires for? Could it be an encoder to feedback information on motor speed.
A: We were not provided any wiring schematic of the motor, or of it
s intended circuit; and as such can only assume that seems to the most reasonable explanation of those wires. What good is a motor that's intended for highly sensitive speed control if there is no feedback signal to confirm speed?
Date Submitted: 01/26/2018
Why ask a question ? YOU have NO answers?
A: We have many answers, but when people ask us things that we have no information about; and no access to the desired information because a product is OEM, or the manufacturer has been dissolved; or any one of a thousand reasons why no information is available, it can seem that way. We feel the same frustrations at not being able to help with accurate answers as much as we would like.
Date Submitted: 12/31/2017
Do you sell or can you recommend a direction switching switch for this motor? Preferably a forward, brake, reverse one? Thank You
A: We have no products rated for operating this motor.
Date Submitted: 12/06/2017
What is the electrical resistance of the motor?
A: We were not provided with that information at time of purchase.
Date Submitted: 06/01/2017
Could 2 of these be shipped in a large flat rate box with flywheels removed?
A: No. They are too large for the large sized Flat Rate box.
Date Submitted: 05/18/2017
I was looking at this motor for my tredmill its a proform 397,model248430.the motor in it is a pmdc C3354B3909 m 2.75 hp tredmill duty @ 130 vdc,2.ohp cont. duty@ 100vdc/1492wts. external fan on pully. This seems like it, would you know if it woul fit? Thank You,George
A: We have no information available to cross reference models, or to tell what will work for a particular application. If the specs and mount are close it may work, but we cannot say for sure.