I am looking for the dimensions of this fitting. I need the dimension from the centerline of the ORB to the end of the flare. I need to see if I can screw these into a valve without hitting each other. Thanks
A: That dimension is approximately 1.085"
Date Submitted: 11/29/2018
My valve ports are 1 1/2" apart, center to center. What are the dimensions of this fitting. I'm trying to figure out if I have clearance to use two normal height or if one will have to be longer. My concern is when I'm installing the second fitting will hit the first and I won't be able to install it.
A: From o-ring port center to JIC tip is 1.167" We mocked up two ports spaced 1.5" on centers, and it will be just touching close. There was a slight enough variation between the two fittings used one would just brush past, but the other would not. The 9-6801-L fittings are not tall enough to clear a standard 9-6801- fitting. We have no jump sizes in the 9-6801-LL series, so one side would have to be bushed up or down, depending on what was used.