My skid steer puts out 33 gpm at 3300 psi would this motor work with my skid steer and if so what would my rpms be and what kind of torque should I expect
A: This motor would easily tolerate the flow, and would produce approximately 639 rpm with 33 gpm input. At the continuous rated pressure of 2900 psi, this motor will generate 5000 in/lbs torque. At the pressure your skidsteer puts out it would produce 5690 in/lbs torque, but must be limited to intermittent operation at that pressure (10% or 6 seconds of every minute). It is always advisable to plumb a pressure gauge into the line to see at what pressure the components are operating.
Date Submitted: 11/14/2018
Would you have a part number for a cushion valve or relief bypass valve for this motor. I want to use it for a saw but want the blade to wind down.
A: 9-8745 is the part number that may work well for your application.
Date Submitted: 01/22/2018
Does this motor use a case drain?
A: These motors have an SAE 4 case drain port. It comes plugged from the factory but can be connected if required.