5 HP GAS ENGINE TO 4F17 PUMP MOUNT Brand new, Hydra-Mount model G10-102 aluminum alloy pump mount for connecting gas engines with 3-5/8" bolt circle and 1-5/8" pilot to hydraulic pumps with 4F17 flange (2" sq. bolt pattern and 1.78" dia.) Includes protective shaft coupling cover.
I have a question about item 4F17 4 bolt pump bracket. How big is the opening on the pump end?
A: The pump end opening is machined to accept the 1.780"-1.7815" diameter pilot of the 4F17 mount.
Date Submitted: 03/20/2018
Will this pump mount have the length to fit the 5 HP Zongshen gas engine (Part # 28-1893) to the 11gpm 2 stage pump (part # 9-7503-11) with this Buna-N Insert (part # 1-3421-X), if not do you have a pump mount that will for these components?
A: It could work, if the center of the insert of the coupler were drilled out to accommodate the pump shaft. The shaft ends are quite close when assembled.
Date Submitted: 12/15/2017
This says that this is for an engine between 3 and 5.5 HP , I am looking to couple a 12HP engine to a 9-7503-16 pump , is there a coupler that is designed for this
A: Item 1-3239 is made for the larger bolt pattern on the 8-16 hp engine blocks.
Date Submitted: 06/19/2017
Will this mount to a harbor freight 6.5 hp engine(212cc) and MTE 2 stage hydraulic 16gpm log splitter pump?
A: This mount typically will fit the smaller bodied gas engines, and most common two-stage pumps with a 4-bolt 4F17 mount. Check the mount measurements against the published dimensions to be sure.
Date Submitted: 05/27/2017
I have a Honda 5.5 with 3 5/8" center holes measured on an angle and a hydraulic pump with 2" centers will this work?
A: It should. That sounds like the standard mounts for small gas engines and 4F17 pumps.
Date Submitted: 07/17/2016
Will this work with a MTE-4501 pump found on an older MTD splitter? MTD Part # 718-0476
A: It should as long as the pump has a four bolt mounting flange with a 2" square pattern.
Date Submitted: 10/21/2015
Would this work with your item number 28-1741 10 HP TECUMSEH GENERATOR ENGINE? Maybe if the tapered part of the shaft was cut off?
A: The bracket and engine will bolt together.
You could remove the crankshaft and machine to whatever you require for your application.
Date Submitted: 08/06/2014
What material is this made of.
A: aluminum alloy
Date Submitted: 06/15/2014
The spec says the is a 5 HP mount. My Briggs 1150 series 11.5 ftlbs 8 hp has the same 35/8 mount pattern. Will this work at the higher horsepower
A: The mount is sufficiently strong to handle the extra HP. Some engines are built with the mount of the lower HP models per an equipment manufacturer's specification.