PTO DRIVE HYDRAULIC GEAR PUMP WITH CAST IRON CENTER Brand new PRINCE model HC-PTO-2AC hydraulic PTO gear pump. Ideal for adding hydraulic power to tractors and landscape equipment not already equipped with hydraulic circuits. Use to power hydraulic motors, front end loaders, mowers, rotary sweepers, etc. Two self-adjusting wear plates. Roller bearings on internally splined shaft. Cast iron center section provides increased wear resistance compared to aluminum centers and is recommended when the pump will be powering a hydraulic motor. Outlet port on both sides for simple hookup. Includes a 1" hosebarb adapter for inlet port, 3/4" NPT adapter for outlet port and a steel plug for one outlet port. Requires the addition of a restraining torque arm to prevent pump body rotation.
why is there a difference between description and your calculator for HP rating. Description says 18.1HP but 11.4GPM @ 200psi in calculator shows 14.8(+ double for gas) or 29.6
A: The manufacturer may be using a test stand to measure the actual hp draw across various specimens of the design. Our calculator is based on the mathematical principles, formula and general rules-of-thumb associated with hydraulics.
Date Submitted: 08/02/2018
Does it matter for this pump which direction the pto turns? If so do you make this pump with both clockwise and counterclockwise directions? I have a 1976 wheel horse d250, which im putting a loader on. Not quite sure which way mine spins yet. Do you know how to judge direction. Do you determine how it spins from looking at the tractor or by sitting on it?? Last question. What size fluid tank do you recommend for this size pump. Thanks in advance for any help you can share with me.
A: The pump can be turned around to match either direction of PTO shaft. You should have 1 gallon of reservoir for each GPM the pump puts out. So about a 12 gallon tank for this item.