1000 RPM DYNAMIC HYDRAULIC POWER TAKE OFF PTO PUMP
Brand new DYNAMIC model GP-PTO hydraulic power take off PTO gear pump. Ideal for adding hydraulic power to tractors,
landscaping and other mobile equipment not already equipped with hydraulic circuits. Use to power hydraulic motors, front end
loaders, mowers, rotary sweepers, etc. Features include cast iron end plates with aluminum center section, self-adjusting wear
plates, roller bearings on internally splined shaft, rear outlet ports and tapped holes on
side for torque arm installation for mounting to prevent pump rotation. Includes a 2" hosebarb adapter for inlet port and 1" NPT
adapter for outlet port.
Disp. 9.76 cu. in. / rev.
Pump Type Gear
Pressure 2500 PSI max.
Speed: 1000 RPM
Flow: 39.3 GPM at 1000 RPM
Mount 2 bolt side for torque arm
Shaft 1-3/8" 21 tooth female spline
Inlet Port SAE 20
Outlet Port SAE 16
Outlet Port Auxiliary SAE 12 NOTE: Included NPT outlet adapter does not fit this port.
I am looking for a PTO pump that produces 26 to 31 GPM with a 3500 PSI output. Do you have a pump in this GPM and PSI range? Thank you
A: We do not have a PTO pump which will safely produce higher than 2500 psi continuously.
Date Submitted: 12/04/2018
I have 64 pto hp will that be enough to power this pump
A: At 1000 rpm this pump will produce 39.3 gpm. That flow at 2500 psi will consume no less than 89 Hp from an industrial gas or diesel engine. You will not have enough power to drive this pump at full PTO speed.
Date Submitted: 09/19/2018
Do you have a chart showing the pump curve of this product? I am wishing to run my tractor at half throttle and that puts the PTO speed at 700 rpm. The implement it is going to run only requires 16 gpm max flow but has a built in bypass system for extra flow.
A: We do not, nor does the manufacturer supply one.
Date Submitted: 08/26/2018
What size electric motor would it require to operate this pump at its full capacity and do you sell that electric motor
A: To operate this pump at it's rated capacity would require 67 Hp electric. The closest thing we have are 75 Hp 3-phase motors. A stabilized jackshaft assembly would need to be engineered to utilize this pump with the intended drive method and speed.
Date Submitted: 06/21/2018
can this pump run ccw direction
A: No, this pump can only be operated in the designed direction.
Date Submitted: 02/22/2018
When the pump is installed on the PTO shaft. The input and output ports for this pump are where on back side. And what size and type hose need from the storage tank to pump input?
A: As installed correctly, the ports will be facing away from the equipment, parallel to the PTO shaft; Inlet above and right of the PTO shaft, Outlet above and left of the PTO shaft. The pump comes with a hosebarb adapter to 2" for solid-wire-reinforced suction line.
Date Submitted: 10/11/2017
Will this pump handle continuous operation at 2200 psi, 22 GPM for running a blower fan on a CASE 1200 planter?
A: That appears to be within it's rated specifications. We would suggest adequate reservoir capacity in any application.
Date Submitted: 03/02/2017
What is the HP Rating at the PTO of a tractor is required to run this PTO Pump. and is there an adapter to go from 21 splines to a 6spline pto adapter.
A: We do not have any adapters to convert 21 tooth spline to 6 tooth spline. If run at 1000 rpm, this pump will draw between 60-90 Hp, depending on the various characteristics of the system.