If the valve with power beyond is the first valve inline from the pump, will there be any pressure drop or flow changes with the next valve inline from the power beyond valve?
A: There may be slight pressure and flow changes dependent on the flow rate through the Power Beyond valve if there are restrictions in the fittings or conductors used; or if the flow is greater than the rated flow of the Power Beyond valve. If the Power Beyond valve is used at the same time as the downstream valve, the Power Beyond valve will consume the flow in proportion to the spool actuation, up to the complete flow if fully actuated.
Date Submitted: 11/06/2018
I have a prince loader valve it looks like the LVT1GB5AB7 model but I am not sure what it is. I need a power beyond sleeve but don't know which one to use can you help me. THANKS
Here is a link to the Manual for that series of valve. If indeed it is a Prince LVT series, a Power Beyond sleeve is not necessary, as detailed. It appears a 1/4" NPT hollow hex plug is used internally to block the passage.
Date Submitted: 08/28/2017
Do I need one or two of these for converting a Prince joystick loader controller on a 1066 ih?
A: That would depend on how it is being plumbed into the system. Typically only one is needed. Please contact our Product Support department to discuss your application.
Date Submitted: 08/08/2017
I have a kobota 2550 and have recently installed a loader configuration with grapple, front end loader,bucket, grapple work great but my 3 point lift does not, I think I need a power beyond sleeve to feed my header block back to the lift,,,,,if you agree send me the correct one for item #9-7556
A: Item 9SV-PB is the correct power beyond conversion plug for your valve. Make sure both valves have a return passage to tank.
Date Submitted: 06/26/2017
will this work for a in place of a NorTrac Power Beyond/Open Center Conversion Plug NorTrac Monoblock Hydraulic Control Valve
A: Based on that item's decsription on Northern Tool's website, no. The port sizes are much different.
Date Submitted: 05/15/2017
do i need the power beyond fitting for an open center hydraulic system? ts100 new holland tractor. thank you
A: We cannot say based on this limited information. Please contact our Technical help department with more details.