RIGHT ANGLE GEAR DRIVE
Brand new, OMNI GEAR model PHD26HD vertical, right angle gearbox. Originally manufactured for PTO driven post hole digger systems.
Tapered roller bearings. Spring loaded triple lip seals. Clockwise input rotation gives clockwise output rotation. Cast iron housing. Designed to free hang from a supporting structure or boom that is connected to it with a 7/8" diameter pin at the top of the gearbox housing. Four 3/8"-16 tapped holes on 3-3/8" diameter B.C. to mount input shaft shield and four 3/8"-16 tapped holes on 4-1/8" diameter B.C. to mount ouput shaft shield. Ships without oil, user must add oil prior to use per user ‘s
Do you sell the coupling that goes on the bottom shaft that connects the auger to
A: No we do not sell that coupler for this gearbox.
Date Submitted: 11/26/2019
Do you carry the yoke for the driveshaft that attaches to this gearbox? It has a special pin hole for a roll pin to hold it on.
A: We do not.
Date Submitted: 01/23/2018
does the gearbox have a position rod on the side
A: There is a through hole cast into the body for a positioning rod to be inserted. It can be found on the lower left hand side as facing the input shaft.
Date Submitted: 12/07/2017
Is the stated max torque the maximum input torque or the maximum output torque?
A: The maximum torque stated is the output torque.
Date Submitted: 11/28/2017
What is the maximum auger blade size that this gear box is rated for? 6 inch, 9 inch, 12 inch, 24 inch?
A: The manufacturer only publishes torque, horsepower, and speed limitations for this box in their literature. They say nothing about auger sizes.
Date Submitted: 05/30/2017
I only see one u-joint you have in your inventory that will accept the 1.25 inch input shaft of this unit, and it is made for a key. Do you have anything that would alow me to make a input shaft for this unit??
A: If you do not want do use the keyed universal joint on the crosspin shaft, we do not.
Date Submitted: 03/11/2017
Do you carry a hydraulic motor and mount to adapt this to hydraulic drive?
A: We do carry hydraulic motors and steel motor mounts. Because of the unknown variables, it's hard to say much else. Please contact our Technical Services department to discuss your particular situation.
Date Submitted: 02/07/2017
Do you carry the PTO connector that attaches the gearbox 1 1/4 shaft to the PTO shaft?
A: You may have to change the yoke at one end of the PTO shaft. Or modify our item 1-2242 for adapting the input shaft of the gearbox.
Date Submitted: 08/30/2015
Will this gear accept anticlockwise operation as well as clockwise operation?
A: Yes it can be turned CCW. The output will also be CCW then.