12 VDC POWER UNIT Brand new, compact 12 VDC hydraulic pump unit. Ideal pump source for building hydraulic power pack systems for lifts and hoists, emergency hydraulic source for mobile equipment and other DC applications.
Can this item be used as a continous duty pump assembly as I'm going to try to use this with a drive project I'm working on
A: No, this item is not rated for continuous duty. At full pressure the duty cycle is one minute on, 5 minutes off.
Date Submitted: 03/22/2016
I want to know if you have a high torque low speed hydraulic motor that would be compatible with your hydraulic power unit (iteam #9-7313) . I know it wouldn't run at full capacity but iam building a hoist for a marine application to pull crab pots that weigh about 100 pounds each .
A: Any motor could be used for this but there are two possible problems. First the pump is very intermittant duty, a couple minutes at a time maximum. Second the flow rate is very low which unless you use a small displacement motor will give extremely low RPM and the small displacement motor may not have enough torque.
Date Submitted: 11/13/2015
in this pump mount, can you index the motor to the left, to protect the power posts. thanks jp 9-7313
A: The motor has just 2 studs for the bracket so the connections have to be either up or down. The whole item could be mounted with the tapped holes on the side and the ports facing vertically.
Date Submitted: 09/17/2015
Is the pump reversible to run a double acting cylinder?
A: The double acting part comes from the type of spool valve you use. That would have to be double acting.
Date Submitted: 03/25/2014
Will this pump run on 24 volts?
A: No this is a true 12 volt motor.
Date Submitted: 02/27/2014
I'm looking for 12v hydraulic pump that is 100% duty for steering set up
A: This pump is not designed to be run continuously. However it can be operated very frequently as the original application for the motor was on a snowplow where adjustments would be made often.