0.22 CU IN DYNAMIC GP-F1-37-T-A HYDRAULIC PUMP
New, Dynamic Model GP-F1-37-T-A aluminum hydraulic gear pump. Two bolt mount on 2-5/16" center, 1-17/64" pilot. Inlet port on the front of the pump, outlet port on the rear.
Disp. 0.22 cu. in. / rev.
Pump Type Gear
Pressure: 2900 PSI Cont. 3626 PSI Int.
Speed: 2000 RPM Cont. 6000 RPM Int.
Flow: 1.9 GPM @ 2000 RPM and 2900 PSI.
Mount 2 bolt
Shaft 25/64" x 3/16" male tang, 9/32" long
Rqd. Filtration 25 micron or better
Inlet Port 23/64" smooth non-threaded port with o-ring on mounting face.
What motor mount/manifold can be used. I need all 15? I have a low pressure oil transfer application in line plumbing. What port size?
A: This pump was designed to mate to the endhead valve section of an electric power unit. Any mounting or manifold would need to be machined for another use. The inlet port is an unthreaded 23/64 hole in the face of the pump, sealing with an o-ring (not included).
Date Submitted: 11/19/2017
Would this pump work with a 5 HP 3450 RPM motor?
A: If you can adequately feed the pump from the inlet on the shaft side face while driving it on that same face, it does seem possible. With only 5 HP, you would only be able to achieve approximately 2200 psi continuously at that speed and corresponding flow rate