2 SPOOL 25 GPM PRINCE RD526CCAA5A4B1 OC VALVE
Brand new PRINCE. Hydraulic control valve for operating double acting cylinders. Monoblock gray cast iron body. Hard chrome plated spools. Load checks. Convertible to power beyond or closed center by changing conversion plug (see related items above).(click here to see the same valve with NPT ports)
Flow 25 GPM max.
Pressure 3000 PSI max.
Relief Valve factory set at 2000 PSI Adjustable 1500-3000 PSI
In/Out Ports SAE 12
Work Ports SAE 10
Mount 3 holes thru body
Size 9-1/2" x 7-1/2" x 3-1/4"
Shpg. 25 lbs.
Spool Details: Spool 1 Double acting spring centered Spool 2 Double acting spring centered
Can a detent kit be added to one spool to operate a motor?
A: A three-position detent (item #9-4895-D) could be added to one of the spools for maintained flow. Keep in mind that the work ports are blocked in neutral, so if there is any flywheeling mass on the shaft or inertia built up by the load there could be shaft failure issues if no relief or bypass is built into the motor circuit to compensate when the spool is returned to neutral.
Date Submitted: 11/25/2018
what is the part number for the power beyond sleeve for this valve
Date Submitted: 02/05/2018
Do you have this valve or a similar on with one spool single acting instead of dual acting?
A: Item 9-6700 is the same valve, but with a single acting spool and NPT porting instead of SAE porting. Unfortunately, we do not have the SAE ported version.
Date Submitted: 07/12/2017
do you have a boot for the levers on this to prevent dirt from getting in the spool?
A: We do not have boots for the individual spools, no.
Date Submitted: 05/01/2017
have a woods duel 165 loader would this work on that
A: This could be used for most any loader. Will handle up to 25 GPM of oil flow, and can be set up for either open center or closed center hydraulic systems. First spool has a float position the lever can detent into.
Date Submitted: 10/26/2015
can valve # 9-7875-f replace 9-7875 ?
A: Yes, the only difference is the -F version has a detented float position on the first spool. This has the work ports open to tank so that a loaded can move up or down to follow ground contour. The float section is slightly longer in the back to allow for the spool being shifted further.